I am trying to get around the fact that we can not setup different Max-On Times for ATO, AWC Drain and AWC Fill...

In order to do this I have the following setup:

Control Circuit 1 - Control Mode ATO, Timer 1, Max-On Time 30 minutes, Level-Input-1 = 1, Level-Input-2 = N/A
Timer 1 is set as "Even Start" and I have 8 events setup (every 3 hours), and every day of the week. This should allow for ATO to happen throughout the day when the time is triggerd AND if the Level-1 sensor shows water is low.

However, an entire day goes by and ATO NEVER triggers. Looking at the Probe/SensorControls/Level and my Control Circuit 1 NEVER shows 'Fill' (nope no alarms either)...

If I change Control Circuit-1 for the ATO to always be on - ATO triggers (fill) when the sensor shows water is low.

What am I missing ?