-
Doser 2 firmware 1.02 update failed
Hello,
I updated to the new GCC and connected to my Doser 2 to update to FW version 1.02. For some reason the FW was interrupted and I got an error message. It said to unplug the Doser 2 for a couple seconds and then plug it back in. I did so and then clicked ok and I saw this for over ten minutes before I clicked cancel. Now my Doser 2 just sits there and flashes yellow (my fluid level is below 2x the minimum amount, hence the yellow flash most likely). Is there an emergency FW flash like there is on the profilux and the mitras? What do you recommend I do now.
Thanks,
Scott
It sat here for 10min, nothing changed.
Last edited by scythanith; 24.12.2014 at 03:00.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks