where is the a description on that the diffrent status leds means?
We will upload a new manual with the LED description today.
how big a container would you typical need for doing the calibration?
For the max. speed you need not more than 1l.
what are the diffrent speeds for? and when dosing smaller amounts would you use the slow one to get a more preciese dosing?
With the max. speed you dose approx. 40 ml per minute and with the min. speed approx. 7 ml per minute. This can vary from pump to pump.
If you dose a big amount you should use the max. speed, for small amounts you should use the min. speed. So yes, the slowest means more precise dosing.
i really wish you would add the ability to get the unit to beep when dosing. its nice when you just have it setup making sure everything is running as you want.
I put it on the wishlist, maybe we can implement it in on of the next firmware versions.
one last thing, the power supply, and the hole to plug it into the unit, is verry lose. if you touch the power cord, just a little the ghl doser loses power, even though when you look at it, it dosent look like its unplugged. If you touch it just a little it also loses power, is this common ? becaus the unit would easly lose power when running, if you by accident just touch the power cable just a little. i am a bit disapointed by souch a simple thing, not being done better.
I will clarify this and will contact you as fast as possible.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks