Hello
I have been trying to get the Doser to work through the PL3 with no luck.
I just bought a new phone cable and have it plugged into S1-4. Programming done.
Thanks,
Hello
I have been trying to get the Doser to work through the PL3 with no luck.
I just bought a new phone cable and have it plugged into S1-4. Programming done.
Thanks,
Last edited by ExpertMarine; 19.11.2014 at 19:24.
Have you used a regular phone cable? You need a 6-wire cable, 4-wire (as often used for phones) doesn´t work.I just bought a new phone cable
Check if you have plugged it into the right socket and if it fits correctly - temp is the lower socket, the upper one is Level 1&2Also my Temperature reads 347*f. How can I adjust that?
The 6-wire cable is called RJ12. I did the same mistake with a phone cable ;-)
Does it require a straight or crossover cable?
Straight. There are no cross cables for phone lines RJ12
I built another cable and finally got it to work. Thanks for your help.
I am still having trouble with my temperature reading 346* f.
What feeder also works with Profilux?
I have two Jebao DC3000 and two RW8 wavemakers. How can I control these off the Profilux3?
Should I post this in another section?
I am waithing om my RW pumps and are going to modify them to be able to controll them with P3.
I am planning to use these. https://www.aquariumcomputer.com/en-...-2f-hic-detail
http://www.ultimatereef.net/forums/s...d.php?t=686942
Hello
I figured out my temp issue, the settings were way off. Keep me in the loop on your pump control. Why use that EVG-AP-2F-HIC? Are you only switching on off or to be able to vary the power? My RW-8 draw less then 1.5A since the PSU is rated at 1.5A . Your relay system seems overkill... Why not do it with the 5V signal?
The only reason is that i want to be able to turn my pumps off.
Your not using a power bar?
I need to get some more goodies myself. This thing is going to be fun playing with all the options.
Bookmarks