Assigning vortech pumps

[gino555]

I have followed the instructions and my vortech controller is flashing green and blue
End and save assignments of all vortech pumps and nothing happens
My controller continues to flash blue green

And my screen says




I ain't having much luck with this!!!

Can any one help ????

[doggydoc10]

Go ahead and reset the vortech itself. Follow instructions on ecotech YouTube channel

[gino555]

Go ahead and reset the vortech itself. Follow instructions on ecotech YouTube channel

I have reset the vortech as per the VC instructions
And the controller displayed a green led

[gino555]

I have reset the vortech as per the VC instructions
And the controller displayed a green led

could it be anything to do with i am running a korrila stream pumps?

just had a look thro the forum looks like this has reoccuring problem

[gino555]

Any chance of a reply ghl?

[GHL Support]

You should follow the Vortech-Controller manual in chapter 4 step by step.

If there are other color codes at the Ecotech pump drivers as described in the manual, the assignment procedure would not work.

Your color code shows blue and green and not blue and yellow as written in the Vortech-Controller manual => wrong mode

[gino555]

You should follow the Vortech-Controller manual in chapter 4 step by step.

If there are other color codes at the Ecotech pump drivers as described in the manual, the assignment procedure would not work.

Your color code shows blue and green and not blue and yellow as written in the Vortech-Controller manual => wrong mode

sorry it is flashing blue/yellow NOT blue/green

I have followed chapter 4 step by step just cant assign pumps


now I have the pump flashing blue/yellow i got to GCC and click end and save assignments of vortech pump and nothing happens should the save changes box show up on GCC when the pumps have been assigned?

[GHL Support]

I've tried it again by myself and it works.

The pump must flash blue and yellow.
Otherwise you followed the instructions not properly and the pump is in the false mode.

As described in Chapter4:

Reseting the pump
- press and hold mode and set until pump color gets red-white-blue
- press and hold mode until color gets red-purple
- press and hold set key until LED gets of and then green
Assigning the pump
- press and hold mode and set until pump color gets red-white-blue
- press set shortly, the pump color is blue-yellow