Results 1 to 3 of 3

Thread: Heater set up

  1. #1
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default Heater set up

    Hey guys.
    How do I set up heater to turn on if temperature goes lower than 75? I have chiller set up at nominal value 77 F and hysteresis .396. Chiller is connected to S1. I have heater connected to S17. Do I just assign temperature 1 and heater as function?
    This will then turn heater on if temperature fall lower than 77?

  2. #2
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    Yes, you assign Temperature 1 and heater to the socket in which your heater is plugged in.

    The time point when the heater is switched on depends on the hysteresis. In the case of nominal value 77 F and hysteresis of 0,396, the heater would turn on if temperature falls below 76,80 F.
    Please have a look at the ProfiLux manual, chapter Hysteresis.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    21.06.2011
    Location
    South Florida
    Posts
    827

    Default

    Thank you

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •