In the PC software there is the option to program a socket (under socket functions) to "Conductivity 1" (if conductivity sensor 1
is the one you refer to, the number can differ) and afterwards you can select control upwards or downwards.
If the measured conductivity value increases a certain value, the socket will be switched on until the desired value is reached again.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks