Hello,
you should update the expansion box firmware:
1. Remove all PAB devices except the expansion box.
2. Connect with the GCC to your profiLux and click Extras->Firmwareupdate in the PAB tab.
3. Confirm the conditions and open the expension box firmware file.
4. Click Yes on the dialog "Do you want to update an Expension Box now?".
5. The next dialog says:
Unbenannt.PNG
Disconnect the expansion box from power and connect it again, thereafter click immediately OK.
6. After update assign the expension box again
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks