Results 1 to 2 of 2

Thread: Controller temperature logic is not start chiller

  1. #1
    Join Date
    10.03.2013
    Location
    Saint-Petersburg
    Posts
    6

    Default Controller temperature logic is not start chiller

    Hello All,

    Today after more than one and half year of operation I faced huge problem. My chiller was not started and temperature was raised to 32C. I did not change any setting a lot of time. What I have:
    Computer: Profilux 3.1N ex
    Chiller: Profilux Propeller Breeze
    Temperature sensor: Profilux probe
    firmware version: 6.06

    Setting in socket function: S3 "Temperature 1" "Chiller". Temperature max deviation +-1,2. Target temperature 26C, Current 30 and chiller was not started in this situation.
    If I setting up "Always On", Profilux Propeller Breeze is working properly.

    What happened? Did anyone face this situation?

    Thank you!
    Vadim

  2. #2
    Join Date
    19.02.2009
    Posts
    2,976

    Default

    Does the temp sensor still show the correct temperature?
    Has the LED lamp been on or off at the socket in which the breezer should have been on?

    For testing you could also try another socket.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •