So Tunze 1 reacts to L1 = Stream pump 1, Tunze 2 reacts to L4 = Stream pump 2.
Have you connected them via splitter to the L-Ports or directly?
If you set L1 and L4 to illumination 1 + 4 - just for testing - and use the function "manual illumination", do the Tunze pumps react then?
Or if you set the voltage to min 1V and max 10V for a moment, do the pumps react?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks