Water level alarm and turning off sockets

[mcrist]

I need some assistance with the programming logic.

I own a ProfiLux 3 with the optical sensor to control water level. This works perfectly but I would like to program the controller to turn off three two sockets when the water level's alarm is triggered.

Every once in a while my skimmer can go crazy and start pulling a lot of water from my tank. This causes the water level to trigger an alarm but the skimmer continues to run. It would be nice to have the water level alarm turn off the skimmer so that it will stop overflowing.

I found a recent thread (dated 11.05.2014) that is very similar to my question but I do not understand the solution that was posted. This is my first attempt at the programming logic and I have not been able to figure it out. I did read the programming logic manual but I did not find it helpful.

My best attempt only turned off the sockets when the water level was adding water to the tank and not when it goes in alarm state.

Thanks