Correct calibration data for redox probe

[mistral]

I have calibrated my new redox probe, linked to my profilux 3.1N ex, and I have had these calibration values:

Value 1 0mv ADC1 450
Value 2 220mv ADC2 549.

Are they good? It is enough a difference of about 100 between the ADC1 and ADC2?

Thanks

[GHL Support]

If it is a new probe, then it's rather unlikely that it is defective.

-What does the probe show in the calibration fluid?
-What does the probe show in your tank?
-Are you sure you have calibrated exactly according to the manual?
-Please note that generally the Redox measurement needs around one week to stabilize.

[mistral]

Dear Carolin,

you didn't answer my question: are my ADC values acceptable, with a difference of about 100 between ADC1 and ADC2?

I have calibrated correctly redox probe. The value measured in calibration fluid is about 223 and in my tank the value is about 210.
I will wait a week.

Thanks