New GHL Control Center version 1.0.4.0 BETA for Mitras and ProfiLux

***Artur*** · 12.03.2014, 17:09

...is available now.

We are glad to announce, that the new version of GHL Control Center supports the ProfiLux 3 controller.
With the GHL Control Center you can simultaneously connect to the different devices like Mitras LX or ProfiLux 3 and make the settings parallel.
Not all ProfiLux 3 functions are supported at the moment, but the software will be extended step by step and will replace ProfiLuxControl in near future.

Following futures were added:
- General settings and informations
Illumination:
- Lightcomposer
- Illuminationchannels display and settings
- Simulation
- Thunderstorm
- Light scenarios
- Illumination overview
- Temperature depending light reduction
Probe/ sensor controls:
- Sensor overview
- Probes

Download

**-Aaron-** · 12.03.2014, 19:49

Does it connect wirelessly to Mitras and Profilux?

**doggydoc10** · 13.03.2014, 00:47

What's going to happen to PLC? Is it all going to be GHL CONTROL CENTER for ALL GHL products?

***Artur*** · 13.03.2014, 08:54

Hello,

no it cant connect wirelessly to Mitras, but You can connect via W-Lan to the ProfiLux.

In near future it will replace the PLC and you can use GHL Control Center for Mitras LX, ProfiLux 3 and new products.

***Matthias*** · 13.03.2014, 09:29

addition:

1. We are working on a direct wireless connecion of PC and Mitras. But this is not so much a software question, it is more the hardware.

2. GHL Control Center will not replace ProfiLuxControl in all cases. GCC requrires ProfiLux firmware 6.00 or higher, since 6.00 is not running on PII we still need PLC for the PII.