Hi,
I have one level port. Can I use a splitter to run optical level sensor and flow meter? Or do I need second port for the flow sensor ?
Thanks
Hi,
I have one level port. Can I use a splitter to run optical level sensor and flow meter? Or do I need second port for the flow sensor ?
Thanks
This depends on your Profilux model.
If you have available Level1&2 or Level 3&4, then you can connect both sensors via Splitter to one level port.
e.g. the Profilux 3 ex offered Level 1&2 and Level 3 (to Level 3 you can connect only one sensor).
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Mine was profilux 2 that was upgraded to 3,
I think the top port says temp and the lower one says level , am not sure if it has any # next to it.
I will check when I go home.
Thanks
I just checked it says level 1 &2 , so all what I need is a flow sensor and a splitter , so I can use my level optical sensor for top off and the flow meter at the same time?
Thanks
Yes, both level functions will work separately.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks