More functionality for dosing pump controlled by Profilux.

[tyuksel76]

Hello,
For 2014 i would like to make my first customers wish.

Currently the dosing pump interface does what it is supposed to do. However i think it can be improved additionally by some extra information. Most of us use it for Balling method and use various canisters with different volumes. It would be nice if an additional interface showed us how many days more the liquid would last or how much is left in canister. Hint: Check the Polish aq. equipment manufacturers products they have some nice ideas.

Also I would like to ask if more precise DC motor is possible to add in future to our dosing pumps for dosing of smaller quantities (like Zeostart 3).

Thanks!

[Anthony Neto]

Hello,
For 2014 i would like to make my first customers wish.

Currently the dosing pump interface does what it is supposed to do. However i think it can be improved additionally by some extra information. Most of us use it for Balling method and use various canisters with different volumes. It would be nice if an additional interface showed us how many days more the liquid would last or how much is left in canister. Hint: Check the Polish aq. equipment manufacturers products they have some nice ideas.

Also I would like to ask if more precise DC motor is possible to add in future to our dosing pumps for dosing of smaller quantities (like Zeostart 3).

Thanks!

It would be nice if an additional interface showed us how many days more the liquid would last or how much is left in canister

Complete agree, that will be very useful and i think its easy to do.

We wait for that

[Matthias]

and this is absolutely whats going to happen in a few weeks - at this very moment I am working on the firmware improvements in regards to the dosing pump support

if you have good ideas which should be implemented: now is the right moment to mention them!

[Anthony Neto]

and this is absolutely whats going to happen in a few weeks - at this very moment I am working on the firmware improvements in regards to the dosing pump support

if you have good ideas which should be implemented: now is the right moment to mention them!

in my opinion is fine, it will apear on the screen? You have ideia how?

Thanks matthias

[doggydoc10]

How about an easier calibration method? Like input ml's to be pumped into GHL center and calibrate pump to that same number and presto!
Not sure if it can be done that simple...

[tyuksel76]

Another idea is adding an alert based on liqiud capacity of container and consumption per each pump.

Sent from my SM-N9000Q using Tapatalk

[Anthony Neto]

Hello Andreas

Would you mind to write in english

[Kaiser]

Hello Andreas

Would you mind to write in english

My English is very bad, excuses please
I had a pair ideas for Matthias. Therefore I wrote on German.

Andreas

[Anthony Neto]

My English is very bad, excuses please
I had a pair ideas for Matthias. Therefore I wrote on German.

Andreas

Ok Kaiser

[Himat]

hello,

Matthias,

would it be possible to have the calibration setting for dosing pump changed to accept input of 1/10 sec (i.e. 37.5).
this would mean more accurate dosing over time, ( 0.5 x 7 dosing would be 3.5 ml more or less dosed using current setting )

Himat