Neuer Benutzer
Vortech MP40
Hi
I have a Profilux 3.1N ex, two Vortech MP40s & the associated module. Everything works fine and I'm making good use of the variable flow patterns.
However, I would like to measure the flow of the two MP40s. It seems to be possible using Eheim pumps ( under the "current pumps" section in the profilux control centre ) and can the flow can be displayed on the Touch. Is it possible to do the same with my two Vortech's so that I can measure the flow of each pump?
Thanks
Robert
GHL Support Team
No, this isn't possible
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Reply With Quote
Bookmarks