Y-splitter for 4 separate channels?

[BarnOwl]

I have 4 separate dim channels. 4 T5 groups of 2x 39w lights go to the two ports on the Profilux II Plus (L1-L2/L3-L4) with two connected EVG-AP2's.
This makes 4 different light curves, very nice!

But now I purchased a Simu-L stick and there is no lighting ports left.

If I get a Y-cable can I connect the simu with one of the L ports without loosing a channel?

[BarnOwl]

Ok, solved (thanks Jens):

Simu-L needs 2 channels. I use 4 channels for T5 so I need a PLM-4L to use the simu. (I thought Profilux II Plus supported 8 channels for lighting as sold)

There goes another 50 Euro's.........

[GHL Support]

(I thought Profilux II Plus supported 8 channels for lighting as sold)

You can in total define 8 separate illumination runs for 8 lamps. Without extension card, there are only 4 1-10V-interfaces available, with this, the control of 4 dimmable and 4 non-dimmable lamps is possible.