Hi!
* I'm going to buy Profilux Plus II, and i would like to plug to it 4 Tunze 6205 pumps, a moonlight and a Sunrise led light!
* Can i do it? How?
Hi!
* I'm going to buy Profilux Plus II, and i would like to plug to it 4 Tunze 6205 pumps, a moonlight and a Sunrise led light!
* Can i do it? How?
Last edited by pedrocho; 08.09.2009 at 11:06.
No you wil need extra L channel so you have to order a PLM-4L or PLM-2L4S
Greets
Piet
GHL ProfiLux Netherlands Distribution and support
Can you put a foto or something?
You can find them on my website
www.claqua.nl
Greets
Piet
GHL ProfiLux Netherlands Distribution and support
only one channel?The 2 leds lights can be connected to the same port?
If you buy e.g. PLM-2L4S, next to the port for further 4 sockets, there will be two more 1-10V-interfaces available (=two channels in one port). With a Y-cable you can connect both LEDs moonlight and sunrise to this port.
For the connection of the 4 Tunze pumps you will need 2 Tunze cables no. 1 and 2 Tunze cables no. 2 + 2 Y-cables to connect them to the ProfiLux and to control each of them independently.
And profilux works that 2 channels independently in the same port?
What is the diffenrence between PLM-4L or PLM 2L4S?
thanks
Pedro
Hello Pedro,
yes, ProfiLux will control the two channels independently, although it is only one port.
PLM-2L4S: one port with 2x 1-10V-interface (2 more channels) + one port for further 4 sockets
PLM-4L: two ports with 2x 1-10V-interface each (4 more channels)
Of course you can also buy a PLM-4L, then you can put each LED in one port and don't have to use a Y-cable - this would even be more easier
If i bought the GHL Profilux Plus II EX , that was one L (port with 1-10V-interface port) than de GHL Profilux Plus II, and use that Y cable, will do the job?
Ono more thing, the GHL Powerbar6D is connected to S1/S4 - Socket outlet port?
Thanks
Regards
Pedro
Bookmarks