You have a PM.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Fast service. The parcel came today friday with the new IC to the dali card .
unfortunately that was not resolved the problem of ghl card. It will not find dali point address.
I have searched the ghl computer after new address but it finds none. blank page,
IMG_3427.jpg
but when I plug in a t5 driver dali dimmable so you can find this driver. I can test if it's the same problem with another led driver
best regards
Christian
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hello.
It works with the T5 light ballast and found a adress 1, but when i connect a led driver with dali it dosent find the adress and the led driver its just a blank view in the display as the picture.
When I connect and try it to the illunination channel the led ligt is on 100% and try to set it to 10% it still light for Max light.
But i will get a new led driver and test with it, it may be the driver witch is broken.
Its the same if i switch the cabel to the dali card
/Christian
Herre is some movie clip when i try to find the driver in the meny
http://youtu.be/8EyJVVs_AVA
/Christian
Obviously the DALI card doesn´t recognize the LED driver due it´s another type of DALI device.
Light tube drivers for T5/T8 are type #1, LED drivers are type #6.-
I don´t know if this is checked by the card or not.
@PIWAWT: Is your statement from post #2 a general statement or have you tested this kind of devices?
Thanks Gunther.
So right the led driver dali is type 6. Hope Caroline/GHL can confirm that it will works with type 6 to
/Christian
Here is what i found about the type
Typical field devices
The DALI interface is described in the IEC 62386 standard. The areas of the standard correspond in each case to a connectable type of device:
– Part 201: Fluorescent lamps (device type 0)
– Part 202: Emergency lighting (device type 1)
– Part 206: Conversion of digital signals to DC voltage signals (device type 5)
– Part 207: LED modules (device type 6)
Bookmarks