I've been checking over and over in the manual, but I cannot figure out how to change the default start- and end time for the Ph controller.
Surely I'm overlooking a simple setting, but where is it?
I've been checking over and over in the manual, but I cannot figure out how to change the default start- and end time for the Ph controller.
Surely I'm overlooking a simple setting, but where is it?
Hello
Under probe/ sensor controls (on your PC) go to PH-value.
On the right in this menu you can set the time as you wish.
I do think that is what your looking for.
Greets
Piet
GHL ProfiLux Netherlands Distribution and support
Ok,that fixed it, tnx!
Bookmarks