]OK, GOT IT FIXED!!
i reinstall FW1.03 and all 4 pumps got assing..i am happy now:
Untitled13.jpg
Erfahrener Benutzer
]OK, GOT IT FIXED!!
i reinstall FW1.03 and all 4 pumps got assing..
Untitled13.jpg
GHL Support Team
I don't think this is a Vortech-Controller firmware issue... because if, there would not work any assignment.
Maybe a mistake in the assignment procedure after all...
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Erfahrener Benutzer
I am also using VM ( rev 1.3 ) to control two MP60 & two MP40, pairing and running smoothly except I make a mistake not assign them in a group so that the pump stopped after pairing with VM.
Erfahrener Benutzer
i am not saying FW bad, i did upgrade from 1.02 to 1.03 and maybe something went wrong, after i re install 1.03 evetything went smooth.
believe me ther eis no mistake on my end as far as pump assigning .
Anyway, its working now and working as per manual so thats the main thing
Thank you Frank for you support
Posting Permissions
Reply With Quote
Bookmarks