Hi I'm new into this forum and I have few question about how to program things such as return pump, dosing pump, and other. I bought the profilux 3 starter pack. I read the manual from one of the admin who post into one of the post here, but a bit confusing. Here are my question and I hope I'll get answer:
1. Return pump: I have Pan World and how do I set-up my return pump to shut down automatically when I don't have enough water to go back into the Display tank or even before it get low to prevent the pump runs dry. Do I need an equipment beside the pump? If so what kind of equipment I need and where can I buy them.
2. Dosing Pump: I hook up my dosing pump into my profilux control. When I set-up manually vs. automatic does it still pump or do I need to press the button for each pump to the amount of liquid I need.
3. Salinity: I read in one of the post that I could monitor the salinity from the controller. My question is where can I get the probe for this. Also I have profilux 3 model so not sure if I have slot for this. Can someone tell if I do. If I don't do I need a equipment for this and what kind and where to buy them.
4. Chiller: I have JBJ model for up to 150 gallon. My question is how do I set-up automic when my temp get high and again do I need equipment for this, what kind and where to buy them.
5. Liquid calibration: Where can I buy these liquid?
6. Skimmer: I have the Diablo Octups skimmer rate up to 250 gallon. My question is how to a program my skimmer to shutdown automatic when I do my water change.
Thank you and I hope someone can answer all my question.
Bookmarks