Profilux won't start up after firmware 6.0 update!

[d2mini]

I just installed the PC software as well as the new firmware.
The firmware update went as expected and I got the message on my PC that said it was updated successfully.
The Profilux then restarted and will not complete start back up. Right after the little fish swims across the screen, there is a message in german that ends in exclamation points and it is only there for a split second before it shuts down. Then it automatically starts back up and repeats this over and over again.

Any help????

[Rotknee]

I had the same problem. Make sure the power to your P3 is plugged into a separate and constant power source and not your Powerbar. Once restarted, you can restore your settings and then plug your P3 back into your powerbar.

[d2mini]

Thank you! Started back up!