I have 1-10v dimmable LED drivers I'd like to connect to the L1/L2 sockets. What's the pin-out of the RJ connection (so I can make my own cable)?
Thanks
I have 1-10v dimmable LED drivers I'd like to connect to the L1/L2 sockets. What's the pin-out of the RJ connection (so I can make my own cable)?
Thanks
this is no secret - you can find this information in the manual for the EVG-AP (on our download site)
Thanks Matthias.
If I'm reading it right, it looks like the table for the X105 connector shows what I need:
Pin2 - 0-10v channel1 ?
Pin5 - 0-10v channel2 ?
Pin3 - Shared ground for above?
It looks like I could trigger full on/off on the LED drivers with pins 4 and 6?
DL
yes, this is correct - 4 and 6 are low-active open collector
Bookmarks