I have attached 2 Koralia (3 & 4) to a dimmable power bar. The bar is connected to L1/L2 port and I have configured the device as followes:
L1-> current pump 1
L2 -> current pump 2
Pump group 1 has 2 pumps (1&2)
Current - permanent opposite
Wave - sinus 10s
The pumps don't seem to respond to changes, they are alway on full speed.
I have tested the voltage on the powerbar and both outlets show 120V not changing at all.
I have connected an incandescent light to the powerbar and they don't change their intensity either.
Any ideas what may be wrong.
Bookmarks