Anyone know if It's possible to control that led using profilux?
Med vänlig hälsning, Björn
Anyone know if It's possible to control that led using profilux?
Med vänlig hälsning, Björn
Anyone??
Med vänlig hälsning, Björn
Due it has a 0-10V input, it should be no problem to connect it to a L-port of the Profilux.
However, there is no ready-made cable for that
Straight to an L-port.
You may use a splitter in between to split the two channels of an L-port and/or use a EVG-AP-2F-HIC to also switch on/off the power.
Thanks!
Med vänlig hälsning, Björn
Does anyone have pictures on how it should be connected and when it works? I have a Profilux II, tried to make a connection with a EVG-AP-2F-HIC to an L port. No light at all unfortunately.
Used a 3.5mm jack plug with to wires, + and - on the EVG.
Thanks!
Thanks, but is it also possible to only use the + and - from the Jack plug with the profilux steering cable?
The driver of the Kessil is in a sealed box and I prefer not to take these original parts apart.
Somebody?
Bookmarks