Level Sensor

[pyrrhusmj]

Ok, I am having a level problem. I come home and the profilux is showing the water level too low. I check the sensor, it functions fine, pump is working and ato container full. I then check the settings and see that I need to reset an error. Once I do, I can raise and lower the level sensor to turn the pump on and off. What might be causing this error?

I have the pump time set to 35 minutes maximum. I have had some heat issues with the MH's turning off using the temp sensor in case that may b interacting somewhere.


Michael

[Matthias]

we nned more information to help you

what are the settings of the level control? maybe a screenshot

[pyrrhusmj]

we nned more information to help you

what are the settings of the level control? maybe a screenshot

Here ya go. I did have the water set at 15 minutes before this screen shot. I am using an aqualifter pump. Today the ATO seemed to work correctly so far.

Michael

[Matthias]

Did you watch what happens during the ATO? How long is the pump active?

Shouldn't the tank be refilled within a few seconds?

[pyrrhusmj]

Did you watch what happens during the ATO? How long is the pump active?

Shouldn't the tank be refilled within a few seconds?

Everything seems to work well during the ATO function. The pump is usually active for about 3 minutes, sometimes a little more or less depending on evaporation rates that day. The pump is just a small aqualifter using airline tubing to fill.


Michael

[rodouma]

Hi, I am facing exactly the same problem with my new optical level sensor! What seems to be the problem?
I am using version 4.06 on my PII.

[rodouma]

I am currently testing the "set max on-time to 0" scenario, in order to bypass the "on-time monitoring" that generates the level errors, but it is a bit risky as there is no safeguard for a malfunctioning socket...