I've noticed that when my Breeze is plugged directly into the wall socket (i.e. not under control of Profilux) it operates at a much faster fan speed (noticeable by both wind force and volume) than when running at 10V connected through the Breeze Control unit.

Do I have a faulty controller or are my settings not correct? (I've tested by setting my Nominal temp at 20C, when the probe was reading 27C, and verified that the L1 output was 10V, but the Breeze was definitely not running at 100%)

Screen Shot 2013-05-26 at 5.06.19 PM.png

I know that there are jumper settings in the controller but not sure what they should be set or changed to if that is what is required.