Remote control shows the same what LCD :-) This is the problem.
Mathias, is it possible to add calibration option from PLC?
Remote control shows the same what LCD :-) This is the problem.
Mathias, is it possible to add calibration option from PLC?
It shows what is needed for calibration, so please describe a little more where you see a problem.This is the problem.
Gunther, please read posts in this topic.
On LCD and on remote control screen I see in second line www.ghl-kl.de
for that, I can't use remote control and LCD for ph problem calibration.
This is an individual fault of your PL, not a general problem. And in fact, no one knows if PLC calibration would work on your device. IMHO it would be to repair your PL instead.Gunther, please read posts in this topic.
this displayed message shows that there is something wrong with your serial number or the internal (secret) validation key (which is a protection against theft of intellectual property)
I guess the S/N or validation key went corrupt acidentally -> we have to recover them
please send an email to me, I can assist you to fix it
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hi Matthias, I've sent you S/N by mail but for till now I didn't get any response.... :-(
Is it possibility to get help with this problem?
I checked my emails but couldn't find something
do you mind to send it again?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Now I'm sending again,
thanks Matthias :-)
Hello, excuse me, did you decide your problem, because i have such trouble with my PL2. I disconnected the bus between monitor and sensor plate. The keys are not reacting, only beep, and www.ghl-kl.de on display. Thank you.
I'm still waiting for Matthias response :-(
Bookmarks