Hi, I'm sorry if this is redundant, but I did come across some other threads that describe doing this and I tried to implement it and have failed.
My setup: P3eX, firmware 5.15, PLC 5.1.6.1
My skimmer is on S18, set to Programmable Logic 1 (5 min blackout delay). My return pump is on S17 and is set as Filter 1 (5 min blackout delay).
G1 is set to Filter 1, delayed on.
I would like the skimmer to turn on after some set delay (I'm testing 10 seconds right now) and, as set above, there is no delay after I initiate a feed pause (Maintenance1), which turns S17 and S18 off, and then cancelling it. Both the return pump and skimmer turn back on at the same time.
Where is the fault in my (programmable) logic?
Bookmarks