new 5.16 for ProfiLux and profiLuxControl 5.1.6.0

[Matthias]

I have trouble with PLC 5.1.6 down loaded sveral times and installed ( even did computer shut down and restart) but program will not run keeps coming up error entry point not found..the procedure entry point InitializecriticalsectionEx could not be located in the dynamic link library KERNEL 32.dll. Yes the three words are there with no spaces.

ok, we found out that the new version does not work with XP - see my other thread to this topic

[JasonK]

Has the 5.16 Firmware been removed from the Download section? Ive installed 5.1.6.0 without issue (Windows 7).

As an FYI, Official Support from Microsoft for XP does not end until April 8, 2014.

[doggydoc10]

Interesting Jason. I also have windows 7 but wasn't able to FULLY download.



Doggydoc

[JasonK]

Win 7 Pro, 32 Bit, and up to date on all MS patches.

[doggydoc10]

Win 7 Pro, 32 Bit, and up to date on all MS patches.

Same here. I wonder what's going on with mine. In am sure I have some hardware issue in my P3



Doggydoc

[Matthias]

we are again mixing topics here!

ProfiLuxControl makes trouble on XP PCs and DoggyDoc had problems with the firmware 5.16

no, this is not a hardware issue

[JasonK]

To my earlier post, i cant find 5.16 in the download section?


Sent from my iPhone using Tapatalk

[doggydoc10]

I believe GHL removed it from download section due to issues... But that is MY UNOFFICIAL ANSWER



Doggydoc

[Matthias]

yes, that's right - until we located the problem doggydoc reported