in our download center
in our download center
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I'll update mine and have a go with it.
Last edited by -Aaron-; 12.04.2013 at 18:40.
Updating mine and BOOM the profilux went dead ??????????
Help!
The profilux seems dead nothing happening blank screen nothing.......
Paul
Did you use the RS-232 cable for the update?
Doggydoc
Hi Doggydoc
Thanks for the quick reply
Yes RS-232 used Id say it was 3/4 way through when it seem to freez and then went blank
Paul
Mine went through ok with no issues, I do suffer anxiety through the process though.
Any ideas how to get it bak working???
Thanks in advance
There's a thread here which gives instructions.
I have trouble with PLC 5.1.6 down loaded sveral times and installed ( even did computer shut down and restart) but program will not run keeps coming up error entry point not found..the procedure entry point InitializecriticalsectionEx could not be located in the dynamic link library KERNEL 32.dll. Yes the three words are there with no spaces.
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
Ok I back up and running but 515 only for now, thanks for the help Arron and DoggyDoc.
Bookmarks