Setting a delay for skimmer?

[Halfmoon]

For maintenance.

I do manual water changes... What I would like to do is have my current pumps, ATO pump, return pumps, heaters and skimmer pumps all turn off when I select maintenance 1. This I have done with a 60 minute timer applied.

Now what I would like to have is my skimmer pump and ATO pump to delay starting by 10 minutes when maintenance has ended, but all remaining sockets to return to their normal state.

x2 Is this possible?

[Matthias]

Use programmable logic

G1: maintenance delayed

Then use socket function g1 for the socket in question

[Halfmoon]

I'm trying to delay the skimmer for 5 minutes after every maintenance, after AWC and I have a skimmate locker switch that shuts the skimmer down when full.
The following PL seems to work except the Skimmer shuts down and returns without the delay.

Skimmer delay 5 minutes:
G1 Input Filter X (Skimmer)
Time 300s
Function Delayed on

Skimmer off during AWC:
G2 Input 1 Water change [Inverted]
Input 2 Progammable logic 1
Function AND

Skimmer off when skimmate locker is full:
G3 Input 1 Digital input 1 (Pressure switch in locker)
Input 2 Progammable logic 2
Function AND

PL 3 is the input for the skimmer socket.

Is this correct? If I use "maintenace delay" on G1 I can't set it to all 4 or even 2 & 3 without using more gates. I think you can see what I'm trying to do, any suggestions?

[Halfmoon]

It does get confusing when stacking gates, didn't think it would be that hard to do what I want.