The lighting program I have written should start at 1400 ramp up slowly untill 1800,then ramp down slowly untill 2200, what's happening is its coming on at 1331 and going off at 2229.?

When I save a pre defined color (in for example, the above light program), when I go to another program, the pre defined color is not there, are they program specific, if so surely as I have that color already in that light program I don't need it untill I'm in another program.??

Once a lighting program is written, you have to load the illumination run, when I clip on test illumination run, it does not work untill the run is loaded to the lamp, surges this would be better to use before you load it to the lamp???

Lastly for now, this has happened on numerous occasions, when I'm testing a light program, I get the message that the cc has stopped responding and windows is looking for solution, the program then closes????

Gazz