1. I am not sure what the problem is - set the L-port you want to use to "airtemp 1", that's it
2. if the current value is under the nominal value the L-port outputs a "negative" voltage, this is correct
since the interface can only output positive voltages the relay-signal is used to indicate the sign (+/-) of the voltage
our PropellerControl understands this and reacts correctly
do you use our PropellerControl or something else?
is the firmware up-to-date?
are all jumpers set in the PropellerControl?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks