I noticed in the night setting you have simulation on at 10pm(22) and ending at 12 noon. that is if you are using 24 hr clock
I noticed in the night setting you have simulation on at 10pm(22) and ending at 12 noon. that is if you are using 24 hr clock
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
not sure what you mean. The software (profilux control) will always go to default untill connected. Also did you save the settings to the mitras then it will be in the controller on the mitras..
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
sorry I should of said GHL control center( software for the mitras)
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
Sorry, right, when the longdatude and latitude are set to my house, then saved and updated, the next time I connect to the lamp, they have both reset to 1, now, my question is, if this is happening like it is, how does the mitras know what the moon phase is.
As is happening, the lunar cycle can't run properly as the lamp has no reference point to work to surely.
Gazz
longitude and latidude are not used at all at the moment, this is for future simulation functions
this does not affect the moon phase calculation!
because the moon phase (full ... new) is the same all over the world
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
ok, is there anyone that can post some screenshots of a typical light run to include moonlighting as a few of us are still seeing problems in this area, i have all but given up on moon lighting and just run a blue at 2%, but i would like to use the moonlight function as it is there to be used.
or better still, could someone please email me a copy of their program where the working moonlight is a definate.
nobody using moonlights
Bookmarks