Originally Posted by
NorwayEagle
Hello again
I have been using the Mitras lamps now for about six months without really doing anything with them. I have not been changing any settings or done any updates, just been really happy with the funcionality and results so far.
But I found out it was about time to do some Investment in time, and eventually see if some new features could be of interest, so I today downloaded the V1026, connected to the master and started the firmware update.
At step 4/5 the process seems to go on forever, or maybe it is halted?
Anyway, after about 20 to 25 minutes my patience is about empty, so I aborted the update.
Is there anything that can fix this, or do I have to let it run for even a longer period?
I've had the same problem, I just cancel after resetting the lights. Reconnect and the firmware is up to date, so it seems to take even though the program gets stuck on 4/5 of the install process. I also have better luck with USB 2.0 as opposed to 3.0.
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
Bookmarks