Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
It is step 4/5 with the following text:
The update is in progress...
Don't interrupt the update in any case
Please wait until the update has been completed
Update completed! Press "Next"
Just now I am doing a third test. For the first time the NeXT button is active during this step. at the first two attempts only the abort was active.
'
It seems like the process is going now without any stops or messages. But the lamps are still set at FW Version 1.05.
if you follow exactly the instructions the update wizard gives you the update should work without issues
if not: check if the update driver has been installed correctly
in step 2/5 the Mitras is in the download mode and the download driver must be active
-> read step 2 exactly, follow the instructions
-> check the driver (click device manager)
MitrasFWUpdateDriver.jpg
(don't get confused, since my Windows is a German version some expressions appear in German)
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I have followed instructions exactly, driver is installed because that is how I find the COM port. It still hangs on 4/5, however like I stated before when I reconnect the Mitras the firmware is correct.
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
As mentioned in my earlier thread I was so stupid to buy a win8 PC...
I cannot follow this advice I am sorry to say.
I made an effort in following the advice of Haxer100 to deactivate electronic drivers to see how this could be of help this time also, but this did not activate any similar to the described LPT & COM settings that is none existing in my Device Manager setup.
Combining Mitras and win8 seems to be a combination that is not for anyone else thanhighly educated PC-nerds
@NorwayEagle,
When I get home from work I will look into this a little further for you....
Post a screen shot of what you do have in your Device Manager screen while you are trying to update the lamps...
Last edited by haxer100; 13.05.2013 at 20:19.
I have followed all the steps with the right com port( com 4) !!! but it is still showing 1.07 not 1.08! what am i doing right?
Bookmarks