GHL Control Center Firmware Update
Just removed the GHL CC and installed version 1.0.2.4 and tried to install firmware 1.08.
Everything goes fine, I get to the last page and it says to unplug the light to reset it and press the ready button.
First there is no ready button, so I press the finish button. Second, the firmware doesn't update and still shows 1.07.
Any help here would be appreciated. Also do I have to update the firmware on the slave or does this happen automatically?
Perry
A screen shot is worth a thousand words...
Profilux 3.1N eX, 3 PAB 6D, Slave Doser, PLM-ADIN, Vortech Controller, PLM-PWC, Leak detector, 2 LX 6100HV Mitras
Controlling a 150 DSA Peninsula mixed reef.
Bookmarks