Hi, just planning my next purchase (after the Mitras) and wanted to confirm my thoughts.

I have a Profilux P3EX, both level ports unused at present.

I want to perform the following:

  • ATO with Optical Sensor for water fill function and fail-safe float sensor for water high level. (1 level Port used, 2 connected sensors via splitter cable 1)
  • RODI Reservoir Float switch (reverse level) to alarm when ATO reservoir is running low of RODI (Second level port used, 1 sensor connected via splitter cable 2)
  • Leakage-Interface with 2 leakage sensors (Is it the leakage interface that takes only 1 level port on the Profilux or do I need to have 2 available level ports 1 for each sensor? I.e. will this only take up 1 sensor port, the second port on the splitter cable 2. Either leakage sensor would trigger the same proactive responsive)


If my assumptions are correct for the above, i would require the following:
2 x PL-LY splitter for 2 level sensors
1 x Leakage interface
2 x Leakage sensors
1 x PL-Optolevel
2 x PL-Floater
(And the necessary mounting brackets for the sensors)

Thanks,
Jason