I´m not sure which of the SteveLEDs board you try to connect. I suggest it´s the http://www.stevesleds.com/uploads/Si...e_11.27.11.pdf (or a similar multi-output board)
In this case the wiring should be as follows (taken from documentation):
- The left RJ12 to profilux L1L2 port
- LEDControl4Passive #1 to driver connector No4 (DC 5V+)
- LEDControl4Passive #2 to driver connector No2 (PWM input)
I´m not sure at this but I think this is a problem of the LED driver itselfWorks pretty Well down to 7-8% then it starts to twinkle irregularly
Bookmarks