Page 2 of 2 FirstFirst 12
Results 11 to 17 of 17

Thread: Master & Slave not synced ?

  1. #11
    Join Date
    03.06.2012
    Posts
    38

    Default

    mine are doing the same since the new firmware

  2. #12
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    thanks to all in this thread, these were very detailed information and helped me to diagnose (and maybe debug) this problem

    I wrote a new version (1.08) and think it is fixed. PMs sent.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #13
    Join Date
    03.06.2012
    Posts
    38

    Default

    that fixed it for mine

  4. #14
    Join Date
    11.11.2012
    Posts
    4

    Default

    Mine is also working correctly

  5. #15
    Join Date
    23.02.2009
    Posts
    70

    Default

    Mine have done it from the start but with Firmware 1.07 it became more noticeable.

  6. #16
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    Quote Originally Posted by chiefzod View Post
    Mine have done it from the start but with Firmware 1.07 it became more noticeable.
    Michael, I just sent you the new 1.08

    Thanks to all who helped me to test the new version!

    The 1.08 is now the official new release version for the Mitras.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  7. #17
    Join Date
    15.01.2013
    Location
    Vancouver
    Posts
    6

    Default

    Mine is also working properly now. Thanks for the great support here!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •