Inability to change default settings

[rreeves]

I was wondering if someone could shed some light on my inability to change the defaults settings of the Mitras *Punny?* I've tried multiple times to get the lighting fixture to recognize the changes that I make into GHL control center (1.0.2.1, 1.0.2.2 and currently 1.0.2.3). I've tried on the last 3 versions of the software and haven't been able to get any alteration from the default. When I go into the illumination run and adjust the times, and save changes, I can get a LPC file to store the data on the computer, but the fixture never "resets" to the alteration of bulb coloration or time changes. I am able to change the thunderstorms oddly enough. When I have the times and kelvin changed and run a manual run, the graph will change to the coloration, but the manual run will still run through the defaults.

I've become VERY ********** with this. Suggestions?

[GazzMan]

You have to transmit to mitras before you save, have you done this

Gazz

[doggydoc10]

Once you hit transmit then save you have then saved

[rreeves]

Thanks.