Hello all,

I bought a WLAN module some time ago but when trying to make it work following the manual instructions I do not get the same response from the system as suggested in the documents.

http://support.aquariumcomputer.com/...N_WLAN_eng.pdf

http://support.aquariumcomputer.com/...d%20Router.pdf


I have Profilux Plus II with the firmware 5.14 (13.07.2012) and I use the Profilux Control 5.1.4.3 software.
Serial number: 1012092002

If I try to set up the IP directly on the Profilux, after "Device address <1>" I am asked whether I want to "save" and it goes out of the menu (instead of moving to the "router" question).

If I try from the P.Control SW, "System" / "WLAN" / " Configuration" I can modify the IP address, then "save" but in the general menu does not allow to "save" therefore I assume the unit does not get the configuration.

It does seem a firmware problem, but maybe I am doing something wrong.

Can you please help me to find the way to configure the WLAN module?

Thanks in advance!
Alex