Oh thanks for your prompt reply, I've tried above setting and working perfectly. It will be fine to have a min-max level control as well.
Oh thanks for your prompt reply, I've tried above setting and working perfectly. It will be fine to have a min-max level control as well.
Great, thanks for your feedback.
I plan to put a comprehensive guide together within the month (this month is very busy for us with the release of the Mitras over here in NA)
Many thanks for everyone who has emailed us about the guide and its usefulness.
Michael,
Just tried the ato and awc.....having some issues.....I am using the expansion box with my p3.... I have sensors connected to a splitter and then into expansion box....I assume these are sensors 3 and 4? What do I enter in as sensor 1 and sensor 2?
Sent from my iPad using Tapatalk HD
Here are some screen shots of what I have.....
Sent from my iPad using Tapatalk HD
Ok.....does it look like I have it setup under control 3 now, but as 3 and 4???
Should I change that?
Sent from my iPad using Tapatalk HD
Ok this is what I have I believe.......
Sent from my iPad using Tapatalk HD
If you look at my screen shots....I have control cir... #3 set to ato & water change (#1).... If you click edit then I have another screen shot showing I have sensor 1 set to 3 and sensor 2 set to 4.....something is wrong though.....not even activating the ato....
Sent from my iPad using Tapatalk HD
I have not yet had a chance to look at a set up using the expansion box, however it can not be that much more different
You may find in your drop down box you see level (2) I am not sure.
The guide above will give you the correct configuration its just a matter of working out how to assign the expansion level ports.
I will ask GHL if they can give some direction on this.
Bookmarks