Video Guide for AWC & ATO Beta release

[aqua_digital]

Please find below a NON official (meaning not GHL) Video guide for AWC and ATO.



Quick video note - Sensor 1 was set as the top sensor and Sensor 2 as the bottom sensor.

I am calling this Beta release as it has not been tested on an aquarium with pumps attached only on a test bed using two float sensors, however as you will see from the video the sockets switch as they should and I see no reason why it should not work in the field.

PLEASE post your feedback with any comments and suggestions how this could be improved if at all required.

Once I have some good working feedback i will add this to our own North American support forum along with the other guides I have done.

[shaggss]

Sorry. But I can't see a link?

[d2mini]

I've gone over the settings 10 times and I still can't get it to work. Won't even start draining.

[aqua_digital]

I've gone over the settings 10 times and I still can't get it to work. Won't even start draining.

In the video do you see the sockets switching? Providing you have exact same settting it will work, however based on email correspondance we have always suspected your sensor it always have been erratic so we will continue your support by email to resolve.

[d2mini]

No, the sockets are not switching.
Just the ATO socket (G3).

[aqua_digital]

Your issue has always been unique, I believe and always have done either you have a fulty sensor or your rubber made bucket (black) is compromising the sensor.

we must continue your individual case as direct support. I have replied to your email

[aqua_digital]

Sorry. But I can't see a link?

????

Cick on the image of the video

[benner]

Michael,

Just tried the ato and awc.....having some issues.....I am using the expansion box with my p3.... I have sensors connected to a splitter and then into expansion box....I assume these are sensors 3 and 4? What do I enter in as sensor 1 and sensor 2?


Sent from my iPad using Tapatalk HD

[benner]

Here are some screen shots of what I have.....










Sent from my iPad using Tapatalk HD

[aqua_digital]

Without having an expansion box set up right now, it will be trial an error as the manual does not mention this portion.

My suggestion would be to enter 3 and 4, the other option is set set up under control 3 as 1 and 2