how to turn sockets off during AWC?

[kassysimon]

OK, So i got this working.

I followed the instructions above and it worked perfectly. What i had done wrong is set the max time to a time that was shorter than the amount of time it took for the water to reach the bottom sensor. If the max on time expires prior to the water level reaching the bottom sensor than the alarm will trigger and the AWC sequence will be canceled. This is written in the manual but no a fine a point is placed on it so i skimmed over it.

So if you want to turn off sockets during a water change do the above.
Set your water change up and off you go.

[BigAl07]

kassysimon what guide/instructions did you use to set up your AWC routine? Can you tell us a little about it?

[kassysimon]

i used the sticky in the forum but it is out dated though it still works, its just a little tricky to follow.

If you like, i could re-write the tutorial to suit the latest ProfiLux Control software to make it relevant for everyone who is upto date and new to ProfiLux.

Would you like me to write a tutorial?

[benner]

I do, I do!




Sent from my iPad using Tapatalk HD

[kassysimon]

OK.

will have it done by tonight.

its only morning here........

[benner]

I can't wait!! Do you use 5.14 software?? It is 10pm here in Ontario,Canada so I am off to bed.....


Sent from my iPad using Tapatalk HD

[kassysimon]

Yep. 5.1.4.3 i think.

Its the latest firmware.

[BigAl07]

i used the sticky in the forum but it is out dated though it still works, its just a little tricky to follow.

If you like, i could re-write the tutorial to suit the latest ProfiLux Control software to make it relevant for everyone who is upto date and new to ProfiLux.

Would you like me to write a tutorial?

That would be AWESOME!!

Where are you located?

[kassysimon]

Im in Australia mate.

Working on it now.

[kassysimon]

Here is the tutorial.

Hope it works for you.