Great work kassysimon
Thanks for taking the time to write this up and provide screen shots!
Great work kassysimon
Thanks for taking the time to write this up and provide screen shots!
No worries mate.
Hope it helps.
Hope it works.....!
This is great thanks so much for your efforts, i was in the middle of writing a tutorial myself to post here today for people to check.
One question I have is how are you diferentiating between RO water refill and SW refill? I see the logic gate for SW but not for RO, the question is how is the system deciding where to pull the water from for the two seperate commands?
matthias wrote this to me when we were putting it together.
"The only thing where it maybe becomes tricky is a combination of ATO and AWC when different water sources are used.
In this case (and only in this case) you can use the programmable logic:
G1 = drain water1 AND AWC for salt water
G2 = drain water 1 AND AWC inverse for RO water"
Last edited by aqua_digital; 07.09.2012 at 16:20.
Mine is a fresh water setup so ATO and AWC draws water from the same source, the mains source (town water), (straight from the tap).
Im by far not a professional when it comes to ProfiLux but i do know what worked for my fresh water setup.
What Matthias wrote is what i would do given your situation.
In a set up like mine where the same water is used for ATO & AWC, mine works perfectly.
THANK YOU!!!! I have a saltwater setup but I am beginning to understand better now.....plus, Michael posted some ato and awc info too!!
Sent from my iPad using Tapatalk HD
Bookmarks