Hi
I have two MEAN WELL ELN-60-48D drivers and both are controling 13 Creed LED
I have a GHL proflux II Plus computer to control them
I have connected the drivers to a EVG-AP-2F-HIC ( PL-0556 ) unit
This is how i connected them:
Driver 1: to EVG 1 power supply ballast 1 and ballast 1
Driver 2 : Power supply 2 and Ballast 2
Main power supply: 220v directky from the powerplug in the wall.
When i turn on the Driver-1 on i can hear a "clik" from the EVG-AP and there are lights and i can turn down the light
When i turn on the Driver-2 on i can hear a "clik" agin but no light.
But if i switch so 2 goes to 1 and 1 goes to 2 there is the same problem. no light in ballast 1
I don't use ground wires only + and - wires.
Bookmarks