i cant connect with my profilux using lan.
it wont get a ip, when i try to config it with hand i cant ping it.
profilux-lan.jpg
should there be serial or lan?
i cant connect with my profilux using lan.
it wont get a ip, when i try to config it with hand i cant ping it.
profilux-lan.jpg
should there be serial or lan?
Post some more pictures from your settings.
will do tomorrow after work, been at it now for 2 nights
this little pic is from the settings before we talked on the phone.
Last edited by greenbee; 11.04.2012 at 20:26.
The built in LAN interface isn't shown as a module.
Are the LAN LEDs glowing/blinking on the LAN port?
Did you connect the ProfiLux to a router?
Please more details on your network and which settings you've made!
hi, the green led is glowing and the amber one is blinking.
i did set the ip manualy in profilux because auto did not work.
profilux-lansetings.jpg
its connected on a linksys wrt 320n router
the ip from the router is 192.168.1.1 its range is from 1.100 to 1.199
i also tryed to manualy put mac adres i found on the lan settings in plc into the router dhcp table with 192.168.1.138 as ip.
i just tryed to conect with laptop and crosscable direct to profilux with laptop ip set as 192.168.1.138, same as profilux and then the ping went ok.
Last edited by greenbee; 12.04.2012 at 17:51.
after the crosscable check with the laptop i connected all the cables again the same way as it was and its working.
wierd but true.
only wonder if there are any templates avalible for the user webpage?
thx for your help.
Bookmarks